Difference between revisions of "FrSky Taranis Radio"
| Line 2: | Line 2: | ||
== Battery == | == Battery == | ||
The stock NiMh battery is rather cheap and low capacity - 7.2V 800mAh. Replacing it extends the use time in the field. Change the radio battery alarm in the "Radio Setup" menu. Note that 72MHz and UHF transmitters normally works best at 12V (more output RF power), requiring a step-up converter or a dedicated external battery pack. | The stock NiMh battery is rather cheap and low capacity - 7.2V 800mAh. Replacing it extends the use time in the field. Change the radio battery alarm in the "Radio Setup" menu. The battery connector on the Taranis is a 2S JST-XH - on a 3S battery solder in a 2S connector from an extension cable to make hooking up the battery easy. Note that 72MHz and UHF transmitters normally works best at 12V (more output RF power), requiring a step-up converter or a dedicated external battery pack. | ||
Always charge LiFe and LiPo TX packs externally - not though the plug on the radio. | Always charge LiFe and LiPo TX packs externally - not though the plug on the radio. | ||
Revision as of 15:13, 14 March 2014
The Taranis is the first hi-end R/C radio based on the OpenTX open source project. The transmitter is packed with features and ways to customize the raido.
Battery
The stock NiMh battery is rather cheap and low capacity - 7.2V 800mAh. Replacing it extends the use time in the field. Change the radio battery alarm in the "Radio Setup" menu. The battery connector on the Taranis is a 2S JST-XH - on a 3S battery solder in a 2S connector from an extension cable to make hooking up the battery easy. Note that 72MHz and UHF transmitters normally works best at 12V (more output RF power), requiring a step-up converter or a dedicated external battery pack.
Always charge LiFe and LiPo TX packs externally - not though the plug on the radio.
- HobbyKing 1500mAH LiFe 3S 9.9v Transmitter pack - safe and low discharge battery
- Zippy Flightmax 1800mAh 9.9V 5C LiFePo4 TX Pack - safe
Fix audio buzz
When using JR-module on the back, especially high powered ones, there is a noticable buzzing sound coming from the speaker. It is caused by RFI noise inductively coupled into the wires inside the radio. By opening it and adding to clip-on toroid eliminates the problem.
