Tasmota Flash Blitzwolf SHP7 Plug

From ivc wiki
Revision as of 18:19, 6 December 2019 by Ivc (talk | contribs) (Created page with "400px|right Blitzwolf SHP7 is a dual socket 16A rated WiFi controllable plug, with individual switches for each socket. It can be pu...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigationJump to search
Tasmota blitzwolf shp7 plug.jpg

Blitzwolf SHP7 is a dual socket 16A rated WiFi controllable plug, with individual switches for each socket. It can be purchased for 14USD on Banggood. It is based on the ESP8285 MCU. Works flawlessly with the Tasmota firmware.

Circuit board

Tasmota blitzwolf shp7 plug top.jpg Tasmota blitzwolf shp7 plug bottom.jpg

Wiring

Tasmota blitzwolf shp7 plug wiring top.jpg Tasmota blitzwolf shp7 plug wiring bottom.jpg

Esptool

Download the Esptool to erase and flash the Tasmota firmware.

Erase flash

Change the right serial-port, e.g. /dev/tty.usbserial-A98AVCSI

user$ ./esptool.py --port /dev/tty.usbserial-A98AVCSI erase_flash
esptool.py v2.5.1
Serial port /dev/tty.usbserial-A98AVCSI
Connecting....
Detecting chip type... ESP8266
Chip is ESP8285
Features: WiFi, Embedded Flash
MAC: 2c:f4:32:c9:d1:91
Uploading stub...
Running stub...
Stub running...
Erasing flash (this may take a while)...
Chip erase completed successfully in 3.7s
Hard resetting via RTS pin...
user$

Now, unplug and plug-in the ground pin from the serial-adapter to reset the ESP MCU. If the following step does not work, try disabling the 3V3 pin instead - as the sudden external power up might not put the MCU in the upload right state.

Upload firmware

Download the latest Tasmota firmware (tasmota.bin)

user$ ./esptool.py --port /dev/tty.usbserial-A98AVCSI write_flash -fs 1MB -fm dout 0x0 tasmota.bin 
esptool.py v2.5.1
Serial port /dev/tty.usbserial-A98AVCSI
Connecting........_____....._____....._____....._
Detecting chip type... ESP8266
Chip is ESP8285
Features: WiFi, Embedded Flash
MAC: 2c:f4:32:c9:d1:91
Uploading stub...
Running stub...
Stub running...
Configuring flash size...
Compressed 575616 bytes to 396460...
Wrote 575616 bytes (396460 compressed) at 0x00000000 in 35.4 seconds (effective 130.1 kbit/s)...
Hash of data verified.

Leaving...
Hard resetting via RTS pin...
user$

Setup

Connect to the device over Wifi as any regular Tasmota device and configure the template to the following:

{"NAME":"Oukitel P2","GPIO":[0,0,52,0,0,0,0,0,0,17,0,21,0],"FLAG":1,"BASE":18}

It provides one ADC0 input, usage undefined at the moment.