Solar Power

From ivc wiki
Jump to navigationJump to search
The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.

Small project to demonstrate solar power, power storage in batteries, and a motor load to spin a propeller.

Parts

Solar power panel.jpg

Bill of materials (BOM):

Alternatives:

Setup

The twin solar panel is providing 4.8Volt 200 mA power, the battery 4.7Volt 1600mAh, and the motor a 4.7Volt 150mA load.

NiMH (Nickle-metal hydride) batteries should normally be charged at 1/10C rate, e.g. 1600/10, 160mA. That means it will take little over 10 hours to charge 1600mA. Trickle-charging at this rate will not overcharge and damage the battery (more). NiMH is not like LiPo batteries where the voltage can be used for cut off. With maximum 200mA from the solar modules, it should be charged in 1600/200, 8 hours. That's about the average length of daylight. Also, charging requires a higher voltage, 6V to charge a 4.8V battery.

If the motor is only used at night and free spinning, it should be able to spin 1600/150, 10.5 hours.

A diode will block the current from the battery to flow back to the solar modules when the sunlight is not bright enough to charge the battery.

Stand

To house all the components, I built a stand out of two sheets of plexi-glass, a threaded rod, a few nuts and washers.

Solar modules like to face the sun (for some reason) and a 90-60-30 degree triangle should work fine to tilt it in the general direction of the sun on daytime. The modules would be fastened on the hypotenuse between the 30 and 60 degree angles. Pythagoras helped to figure out the correct measurements.

Drawing and measurements:

Solar power drawing.png

You can download the hand sketches here.

Bill of materials (BOM):

  • 2x 30x20x0.3 cm plexi-glass sheets
  • 1x M6 threaded rod
  • 18x M6 nuts
  • 4x M6 washers
  • 12x M6 wide-washers

The final build took a few hours to complete. I used a sheet of plexi-glass I already had laying around, that's the reason for the extra holes on the top sheet.

Solar power stand front.jpg Solar power stand back.jpg Solar power thread top.jpg

Solar power stand side.jpg Solar power stand side closeup.jpg Solar power stand side topdown.jpg

Plexi-glass is so fun to photograph, the cut edges always light up.

References