FrSky DHT RSSI configuration

From ivc wiki
Revision as of 19:36, 12 August 2012 by Ivc (talk | contribs)
Jump to navigationJump to search

The FrSky DHT is a flexible and relatively powerful 2.4 GHz transmitter. The kit comes as a DIY package with an RP-SMA connector which makes it easy to switch antennas. The communication is two-way allowing for both Tx and Rx signal strength indication (RSSI). The ACCST system shifts 80 channels around hundred times per second in the 2.4GHz band, similar to FSK.

I will use an D6FR receiver in this setup.

Serial adapter

To connect to the transmitter you need a USB-to-serial adapter. FrSky makes one with the necessary pin-header.

Frsky usb cable.jpg

Plug the black header into the corresponding four pins on the transmitter. Power will be provided by the USB-port.

RSSI configuration

The DHT provides a serial data port for configuration of the alarms for the RSSI and the two analog inputs. Download the 3rd-party configuration program and the required drivers.

Frsky config.png

Antenna testing

To get an idea of how well the different set of antennas would perform, I swapped the antennas one by one and recorded the Tx and Rx values from the configuration application.

  • Transmitter: FrSky 2dbi rubber duck antenna
    • Receiver: FrSky 2dbi rubber duck antenna - RSSI Tx: 99 - RSSI Rx: 99
    • Receiver: Dipole 33 mm wire antenna - RSSI Tx: 99 - RSSI Rx: 99
    • Receiver: Dipole 30 mm wire antenna - RSSI Tx: 99 - RSSI Rx: 99
    • Receiver: Generic Wifi whip antenna- RSSI Tx: 99 - RSSI Rx: 99
  • Transmitter: Generic 2.4 GHz 14 dBi patch antenna
    • Receiver: FrSky 2dbi rubber duck antenna - RSSI Tx: 99 - RSSI Rx: 99
    • Receiver: Dipole 33 mm wire antenna - RSSI Tx: 99 - RSSI Rx: 99
    • Receiver: Dipole 30 mm wire antenna - RSSI Tx: 99 - RSSI Rx: 99
    • Receiver: Generic Wifi whip antenna- RSSI Tx: 99 - RSSI Rx: 99