Difference between revisions of "Electric Bobby Car Hoverboard Upgrade"
|Line 24:||Line 24:|
== Overview ==
== Overview ==
Revision as of 17:53, 14 March 2019
This project puts four 350W hoverboard motors in a Big Bobby Car toy vehicle, to give it independent four wheel drive and a top speed of 29km/h with turbo activated. All controlled by two potentiometer triggers on the steering wheel.
- Project start: January 2019
- Main controller: STM32F103 72MHz ARM Cortex-M3 core
- Flasher: ST-Link V2 Programming Unit clone
- Motors: 4x direct drive 3-phase brushless DC electric wheel hub motors with hall effect sensors, 350W ea
- Tire type: non-pneumatic rubber tire, road pattern
- Tire size: 7-inch / 170 mm
- Battery: Lithium-ion rechargeable 18650-cells, 10S2P 36V 4400mAh 158.4Wh pack with XT60 connector
- Upgrade: Controller can handle 13S (48V), 12S battery upgrade easiest
- Charger: Lithium-ion charger 42V 2A 3-pin connector with built-in fan
- Upgrade: External charger for anything else
- Internal connectors PCB: JST Sales America B4B-XH-A 2.5mm pitch
- Vehicle base type: BIG New Bobby Car Red
- Dimensions assembled: L57 x W30 x H39 cm
- Original load-bearing: 50 kg max.
A rough overview of the components in the system.
- File:Hoverboard schematic full reverse.pdf - Full reverse engineered schematic of the classic hoverboard circuit board
- File:Hoverboard schematic simple reverse.pdf - Simple schematic the circuit board
Pin-out of the hoverboard connections, by NiklasFauth:
STM32F103 MCU pin-out:
Throttle filter and connection board
This is a PCB I designed to break out the ADC/UART/PPM/I2C signals to make it easier to finish the build. It also adds filtering to the analog signals and pull-ups to the I2C lanes. All configurable via solder-jumpers. Inspired by the Jan Henrik break-out boards.
- File:Bobbycar hoverboard throttle breakout schematic.pdf - Schematic of the throttle filter and connection breakout board