Difference between revisions of "BlueSolar 100-15 True MPPT solar charge controller"
From ivc wiki
Jump to navigationJump to search
(→Specs) |
|||
| Line 22: | Line 22: | ||
[[Image:BlueSolar_100-15_charge_controller_schematic_partial.png|500px]] | [[Image:BlueSolar_100-15_charge_controller_schematic_partial.png|500px]] | ||
== References == | |||
* [https://www.victronenergy.com/solar-charge-controllers/mppt7510 BlueSolar MPPT 75/10, 75/15 & 100/15] | |||
* [https://www.victronenergy.com/support-and-downloads/software Software and white papers] | |||
Revision as of 21:06, 2 December 2016
The BlueSolar series of charge controllers are some of the latest and most efficient MPPT controllers available. The BlueSolar 100-15 controller is based on a Freescale MC9S08AC32 40MHz MCU, can handle up to 100V 15A PV installation, hence then model name. This allows up to 400W of PV on a 24V battery setup, which is pretty much for such a relatively small controller.
Specs
- Type: MPPT charge controller with load output
- Micocontroller: Freescale MC9S08AC32 40Mhz MCU
- Switches: MOSFET N-channel 100V/180A/5mOhm, 40V/190A/2.5mOhm for load output
- Max. PV voltage: 100V
- Max. PV current: 15A
- Max. load current: 15A
- Battery voltage: 12V or 24V, auto-detect
- Battery fuse: 20A blade fuse
- Protection: Over-voltage, over-temperature (buck converter), low-battery voltage cut-off, battery management
- Terminals: screw terminals, max. 6mm2/10AWG
- Monitoring: Two LEDs, remote VE Direct RS232 communication cable to a computer or meter device
- Auxilary port: JST-PH 4-pin 2mm pitch connector, pinout GND-RX-TX-5V
- Firmware: Upgradable via VE Direct RS232 cable and software
- Size: 113.9 x 100.7 x 46.9 mm
Schematic
The following is a partial reverse-engineer of the power stage of the charge controller, no logic or support circuitry is included.
