TBS Discovery setup

Setup guide for my TBS Discovery.

Flight mode

When using the FrSky D6FR 6-channel receiver on a Spektrum DX7 , only the Gear-channel is available on the receiver. To be able to use the three-position switch, it is necessary to set the Aux2-channel to F.mode (Flight mode) and map the Aux2-channel to Gear [1].

1. Enter system mode, hold down left hand buttons while powering on and scroll to Input Select
2. Set Aux2 to F. Mode and Gear to INH, exit the system mode
3. Go the function list and select Prog.Mix1
4. Set to Aux2 > Gear
5. With f.mode switch in pos 1, set Rate +100%
6. With f.mode switch in pos 3, set the second rate value to +100%
7. The last 2 parameters should be set to defaults of SW:ON and OFFSET:0
8. Now go to the Monitor Screen and check that the gear channel slider follows the Aux2 channel by moving the f.mode switch through it's range
9. Reset the travel range for the Gear channel or Aux2 channel if necessary to get the full range