FrSky DHT RSSI configuration

The FrSky DHT is a flexible and relatively powerful 2.4 GHz transmitter. The kit comes as a DIY package with an RP-SMA connector which makes it easy to switch antennas. The communication is two-way allowing for both Tx and Rx signal strength indication (RSSI). The ACCST system shifts 80 channels around hundred times per second in the 2.4GHz band, similar to FSK.

I will use an D6FR receiver in this setup.

Serial adapter

To connect to the transmitter you need a USB-to-serial adapter. FrSky makes one with the necessary pin-header.

Plug the black header into the corresponding four pins on the transmitter. Power will be provided by the USB-port.

RSSI configuration

The DHT provides a serial data port for configuration of the alarms for the RSSI and the two analog inputs. Download the 3rd-party configuration program and the required drivers.

Antenna testing

To get an idea of how well the different set of antennas would perform, I swapped the antennas one by one and recorded the Tx and Rx values from the configuration application.

All the tests where performed with a FPV VTX 1180 MHz without low pass filter running 20 cm away from the receiver and everything was done indoors with antennas about 12 meters apart in separate rooms.

• Transmitter: FrSky 2dbi rubber duck antenna
  • Receiver: FrSky 2dbi rubber duck antenna - RSSI Tx: 37 - RSSI Rx: 66 - Without VTX Tx 62 Rx 70
  • Receiver: Generic Alfa 5dbi rubber duck antenna - RSSI Tx: 52 - RSSI Rx: 71 - Without VTX Tx 67 Rx 71
  • Receiver: Dipole 33 mm wire antenna - RSSI Tx: 41 - RSSI Rx: 74
  • Receiver: Dipole 32 mm wire antenna - RSSI Tx: 49 - RSSI Rx: 73
  • Receiver: Dipole 30 mm wire antenna - RSSI Tx: 62 - RSSI Rx: 78 - Without VTX Tx 59 Rx 70
  • Receiver: Dipole 29 mm wire antenna - RSSI Tx: 54 - RSSI Rx: 74
  • Receiver: Dipole 29 mm wire antenna - RSSI Tx: 54 - RSSI Rx: 74
  • Receiver: Dipole 27 mm wire antenna - RSSI Tx: 51 - RSSI Rx: 74
  • Receiver: Generic Alfa 2.4 GHz 14 dBi patch antenna - RSSI Tx: 73 - RSSI Rx: 79 - control

• Transmitter: Generic Alfa 5dbi rubber duck antenna
  • Receiver: FrSky 2dbi rubber duck antenna - RSSI Tx: 37 - RSSI Rx: 54 - Without VTX Tx 62 Rx 71
  • Receiver: Dipole 33 mm wire antenna - RSSI Tx: 52 - RSSI Rx: 78
  • Receiver: Dipole 32 mm wire antenna - RSSI Tx: 41 - RSSI Rx: 74
  • Receiver: Dipole 30 mm wire antenna - RSSI Tx: 57 - RSSI Rx: 77 - Without VTX Tx 64 Rx 73
  • Receiver: Dipole 29 mm wire antenna - RSSI Tx: 49 - RSSI Rx: 74
  • Receiver: Dipole 27 mm wire antenna - RSSI Tx: 54 - RSSI Rx: 68

• Transmitter: Generic Alfa 2.4 GHz 14 dBi patch antenna
  • Receiver: FrSky 2dbi rubber duck antenna - RSSI Tx: 73 - RSSI Rx: 83 - Without VTX Tx 75 Rx 82
  • Receiver: Generic 5dbi rubber duck antenna - RSSI Tx: 78 - RSSI Rx: 87 - Without VTX Tx 79 Rx 82
  • Receiver: Dipole 33 mm wire antenna - RSSI Tx: 74 - RSSI Rx: 83
  • Receiver: Dipole 32 mm wire antenna - RSSI Tx: 73 - RSSI Rx: 82
  • Receiver: Dipole 30 mm wire antenna - RSSI Tx: 74 - RSSI Rx: 81 - Without VTX Tx 67 Rx 77
  • Receiver: Dipole 29 mm wire antenna - RSSI Tx: 74 - RSSI Rx: 82
  • Receiver: Dipole 27 mm wire antenna - RSSI Tx: 74 - RSSI Rx: 82

• Transmitter: Generic Dealextreme 2.4 GHz 14 dBi flat panel antenna
  • Receiver: FrSky 2dbi rubber duck antenna - RSSI Tx: 73 - RSSI Rx: 82 - Without VTX Tx 76 Rx 82
  • Receiver: Generic 5dbi rubber duck antenna - RSSI Tx: 78 - RSSI Rx: 85 - Without VTX Tx 79 Rx 85
  • Receiver: Dipole 33 mm wire antenna - RSSI Tx: 73 - RSSI Rx: 81 - holding the panel 90 degrees to the side to match the vertical dipole polarity
  • Receiver: Dipole 32 mm wire antenna - RSSI Tx: 73 - RSSI Rx: 82
  • Receiver: Dipole 30 mm wire antenna - RSSI Tx: 72 - RSSI Rx: 80 - Without VTX Tx 75 Rx 82
  • Receiver: Dipole 29 mm wire antenna - RSSI Tx: 76 - RSSI Rx: 83
  • Receiver: Dipole 27 mm wire antenna - RSSI Tx: 74 - RSSI Rx: 82

As a side-note, the dipole wire antenna should have an exposed core with the length: 299792458/1000/2440/4*0.95 = 29.18 mm (speed of light/1000/middle of band/quater wavelength*velocity in conductor)

VTx harmonics interference

While the video transmitter was turned on, the harmonics caused the RC control signals to be attenuated. The list below shows the interference through all the 15 channels.

Channel - Frequency - Rx RSSI - Tx RSSI

• no vtx 57 66
• 1 1000 52 67
• 2 1020 49 66
• 3 1040 49 69
• 4 1060 48 69
• 5 1080 43 66
• 6 1100 41 69
• 7 1120 45 68
• 8 1140 39 71
• 9 1160 35 62
• A 1180 35 61
• B 1200 37 62
• C 1220 39 60
• D 1240 52 67
• E 1260 52 67
• F 1280 46 67