Cloverleaf FPV antenna

This is a circularly polarized aerial antenna spesially designed for FPV use. Because of the almost ideal 1.2dBi isotropic radiation pattern, it is suitable as a transmitter antenna (transmitting video signal down to ground). Because it has only three lobes, the generated drag is low. The lobes is key to get an uniform radiation pattern.

Construction

The video below shows the design and construction of the antenna.

Radiation pattern

The images below show the radiation pattern on the horizontal and vertical axes.

Build

Fortunately the original inventor of the antenna, IBCrazy, has provided an excellent guide on how to construct the antenna. Only a few parts are needed.

0.8 mm MIG welding wire - ask your local car or repair shop
SMA connector - either RP-SMA or SMA depending on the transmitter output
50 Ohm RG58 coax cable - short piece
Solder, pliers, knife

The antenna below is right hand circular polarized and should be used with another right hand circular polarized antenna for best performance, with a linear antenna a 3dB loss will endure. I aimed for 2510Mhz when creating my antenna as the frequency provides a lower noise-floor and is used for aerial video in Europe.

Using the formula provided by IBCrazy and my desired way of mounting the lobes to the side of the connector shaft, I ended on the following wire length:

Wire length in mm = 307022/f in MHz = 307022/2510MHz = 122.32mm for the base wire
Add 3mm for mounting = 122.32mm + 3mm = 125.32mm
Subtract the distance from the coax center to the side = 125.32mm - 2mm = 123.32mm

I cut three pieces of MIG wire and sanded down the ends. Then, began bending one end to ¼th wavelength. Measure from the end to the inside of the bend.

¼th wavelength = 307022/2510MHz/4 = 30.58mm

Next, on the other end of the wire I bent the second bend at the following point after including the short mounting bends (3 mm for mounting, 2 mm from the coax center).

Ground bend = 30.58mm + 3 mm - 2 mm = 31.58mm

Bend the middle section of the U-shaped wire into an arc so that the two ends meet.

Lastly, position the last 31.58mm length on the pliers and adjust the angle to be perfect 45 degrees to the left, when viewing from you. Measure 3 mm in and bend the short mounting taps.

The hard part is to solder the short mounting taps on the side of the connector and then aligning all the three other ends on the center conductor.