Difference between revisions of "MakerBot Replicator 1"
From ivc wiki
Jump to navigationJump to search
(Created page with "A few steps to keep the MakerBot running smoothly and continously. == Improvements == * Add blue thread-lock to all grubscrews on all the axis to prevent them to fall out * Use ...") |
|||
| Line 2: | Line 2: | ||
== Improvements == | == Improvements == | ||
* Add blue thread-lock to all grubscrews on all the axis to prevent them to fall out | * Add blue thread-lock to all grubscrews on all the axis to prevent them to fall out [http://www.youtube.com/watch?v=v3cnEr1sriQ&feature=plcp] | ||
* Use Triflow lubricant or similar to all metal-to-metal mechanical motion | * Use Triflow lubricant or similar to all metal-to-metal mechanical motion | ||
* Replace the system fan with a large 80x80 mm fan to reduce noise | * Replace the system fan with a large 80x80 mm fan to reduce noise | ||
* Add a adhesive label on the right side of the joy-pad to indicate the insertion point for the SD card | * Add a adhesive label on the right side of the joy-pad to indicate the insertion point for the SD card | ||
Revision as of 21:30, 2 August 2012
A few steps to keep the MakerBot running smoothly and continously.
Improvements
- Add blue thread-lock to all grubscrews on all the axis to prevent them to fall out [1]
- Use Triflow lubricant or similar to all metal-to-metal mechanical motion
- Replace the system fan with a large 80x80 mm fan to reduce noise
- Add a adhesive label on the right side of the joy-pad to indicate the insertion point for the SD card
