FPV

Flying electronic RC planes from the ground is fun. Piloting a FPV plane from First Person View is really cool. With the arrival of light and powerful video stream transmitters and long range remote RC transmitter modules , the range of flight has increased from line-of-sight to an order-of-magnitude wider.

Research

To build a reliable platform I want to begin with the fundamental basics and then extrapolate more specific products.

1. Lower frequency will allow greater range, longer wavelength requires larger antenna
   • Higher frequencies, 2.4GHz or 5.8GHz, will quickly get attenuated by the atmosphere
2. One energy-source, single set of batteries for motor, camera, OSD, VTx, Rx, servos
   • Minimized weight, as batteries contribute as the heaviest component
3. Parallel 3S 11.1V Lithium-ion Polymer batteries, both on plane and ground station
   • Prevents voltage drop if one cell is bad
4. Power- and signal-wiring separated as much as possible
   • Noise from motor can degrade digital signals if coupled with signal-wires
5. Shielded components and twisted wires to eliminate noise and oscillation, PCB ground plate facing interference source
   • Minimize both ambient noise and interference from nearby components, think of a long wire as an antenna that picks up anything
6. Video-transmitter on a higher frequency band than RC-transmitter, 1.3GHz VTx and 433MHz RCTx
   • Having the same frequency/band on VTx and RCRx will cause signal degradation
7. Video-transmitter, as well as RC-receiver, powered by 5V voltage from main Lipo-batteries
   • When the main engine batteries are drained, for 3S the low voltage limit is 9.6V, the rest of the system can still function
8. Clone aileron servo signal to use two servos per wing
   • Prevent loss of control on servo failure, must be mounted close together to drive force-drive the dead servo, might drop this
9. Proper cooling of video-transmitter using an appropriate heat-sink and thermal-adhesive

Gear

Video system

• Lawmate - Range of different models
• EagleEyes
• Immersion RC Duo 2400 diversity receiver

On-Screen Display

• ImmersionRC EzOSD
• ET
• DOSD

Goggles

• Fat Shark RCV230T/922T Teleporter - All-in-one, limited 320x240 resolution and range [1]
• Fat Shard RCV922 Aviator - Video input, 640x480 resolution, Vin 6-12V [2]

Control system

Radios

• Futaba 6EXP PPM/PCM 1024 35MHz [3]
• Futaba 9CHP-PCM 36MHz [4]

Transmitters

• ImmersionRC EzUHF transmitter - Module connects to trainer-port on radio, 433 MHz frequency, 200mW or 600mW power-mode prototype model
• Dragon Link transmitter - Transmits at 433MHz, 500mW [5]
• Thomas Scherrer OZ2CPU UHF system

Receivers

• ImmersionRC EzUHF receiver - 8-channel receivers, diversity signal/dual antenna
• Dragon Link receiver - 500mW

Other

• ImmersionRC EzAntennaTracker - Uses GPS-coordinates from EzOSD inserted in the right audio channel

Planes

• Ritewing Zephyr - Foam wing base
• Multiplex Easystar - Simple glider-plane [6]
• ParkZone Radian PNP - Glider, prop in front, huge easy to spot [7]
• EasyStar - Cross between glider and sport plane, 3-channel, easy to modify [8]

Other

Motor

• Hacker A30-L

Batteries

• Turnigy S3 2200 mAh

Charger

• Bantam BC-6 - Korean, high quality