Difference between revisions of "Audio power amplifier"
From ivc wiki
Jump to navigationJump to search
(→Final) |
|||
| Line 15: | Line 15: | ||
== Measurements == | == Measurements == | ||
Measuring the input and output signal using a oscilloscope will verify if the circuit is designed correctly, which it turned out to be. | Measuring the input and output signal using a oscilloscope will verify if the circuit is designed correctly, which it turned out to be. | ||
Here the amplifications is about 25 (9.8V/0.4V). | |||
[[Image:Audio_amplifier_oscilloscope.png|400px]] | [[Image:Audio_amplifier_oscilloscope.png|400px]] | ||
Revision as of 13:11, 14 March 2010
This was a electronics course project, building an audio amplifier based around the LM1875 op-amp.
Circuit
The circuit was constructed after calculating the amplification, upper and lower frequency band, according to the specifications.
Final
This shows the final circuit, mounted to a flexi-glass plate to balance the enormous heatsink and protect the bottom traces.
Measurements
Measuring the input and output signal using a oscilloscope will verify if the circuit is designed correctly, which it turned out to be.
Here the amplifications is about 25 (9.8V/0.4V).
Report
- Project report: Effektforsterker for lyd (Norwegian)
