Difference between revisions of "Audio power amplifier"

Revision as of 20:04, 19 February 2011

This was a electronics course project, building an audio amplifier based around the LM1875 op-amp.

The circuit was constructed after calculating the amplification, upper and lower frequency band, according to the specifications.

This shows the final circuit, mounted to a flexi-glass plate to balance the enormous heatsink and protect the bottom traces.

Measuring the input and output signal using a oscilloscope will verify if the circuit is designed correctly, which it turned out to be.

Here the amplifications is about 25 (9.8V/0.4V).

Revision as of 12:56, 17 May 2010 (view source) Ivc (talk \| contribs) ← Older edit		Revision as of 20:04, 19 February 2011 (view source) Ivc (talk \| contribs) Newer edit →
Line 1:		Line 1:
			[[Image:Audio_amplifier_overview.jpg\|300px\|right]]
	This was a electronics course project, building an audio amplifier based around the LM1875 op-amp.		This was a electronics course project, building an audio amplifier based around the LM1875 op-amp.