Electric Hoverboard Monorover R2 Teardown

From ivc wiki
Revision as of 19:33, 25 July 2015 by Ivc (talk | contribs) (→‎Battery)
Jump to navigationJump to search
Hoverboard content.jpg

The Monorover R2 is an electric self balancing hoverboard - based on two individual motors joint at a central axis-point. It is an efficient way to get around your neighborhood, park, to the shop, in the mall and other relatively flat surface areas.

Technical specifications

  • Released: January 2015
  • Product code: DAT-N1
  • Manufacturer: Shanghai DAT Electric Vehicle
  • Type: self balancing hoverboard
  • Main controller: STM32F103 ARM Cortex-M3 core
  • Balancing controllers: 2x STM32FEB ARM Cortex-M3 core
  • Balancing sensors: 2x InvenSense MPU-605 MEMS 3-axis gyroscope and 3-axis accelerometer
  • Motor: 2x direct drive 3-phase brushless DC electric motor, 36V 350W, 700W total
  • Tire type: non-pneumatic hollow rubber tire, 170 mm
  • Activate: switch pads for both feet
  • Lights: 2x blue tinted LED windows
  • Work temperature: -10°C to 40°C, peak performance at 10 to 30°C
  • Environment protection: IP54 - dust protected, splashing of water
  • Battery: Lithium-ion rechargeable 18650-cells, 10S2P 36V 4400mAh 158.4Wh pack with XT60 connector
  • Charger: Lithium-ion charger 42V 2A 3-pin connector with built-in fan
  • Dimension: 58.5 x 18.5 x 18.0 cm
  • Weight: 10kg
  • Warranty: 1 year

Usage specifications

  • Road surface: relatively flat, no more than +-25mm bumps (asphalt, grass, fine gravel)
  • Maximum speed: about 10km/h, begins to beep but keeps going
  • Max riding angle: 15°, vary depending on rider's weight, road condition and temperature
  • Range per charge: 20km
  • Ride height: 110 mm
  • Ground clearance: 30 mm
  • Turning radius: 0°, on the spot
  • Tire-to-chassis clearance: 5 mm
  • Max load: 100kg
  • Min load: 20kg
  • Charge time: 2 to 3 hours

Battery

Hoverboard battery pack.jpg

Hoverboard battery pack spec1.jpgHoverboard battery pack spec2.jpg

The battery in the hoverboard is a single 18650-cell based Lithium-ion battery pack with XT60 connectors - no balancing leads.

Upgrades

The 18650 pack can be upgraded to any battery pack with 36V output voltage, meaning you can use two 18V backs in parallel to get 36V. Any capacity will work, minimum 3000mAh recommended, as long as the size does not exceed 135x85x58mm.

The following suggestions can be connected two in parallel and externally charged.

  • Turnigy nano-tech 3300mah 5S 65C Lipo Pack - total 6600 mAh capacity
  • Turnigy nano-tech 3850mah 5S 65 Lipo Pack - total 7700 mAh capacity

Control boards

Main board

Sensor boards