Difference between revisions of "BlueSolar 100-15 True MPPT solar charge controller"
From ivc wiki
Jump to navigationJump to search
(→Specs) |
(→Specs) |
||
Line 4: | Line 4: | ||
* Type: MPPT charge controller with load output | * Type: MPPT charge controller with load output | ||
* Micocontroller: Freescale MC9S08AC32 40Mhz MCU | * Micocontroller: Freescale MC9S08AC32 40Mhz MCU | ||
* Switches: MOSFET N-channel 100V/180A/5mOhm, 40V/190A/2.5mOhm for load output | |||
* Max. PV voltage: 100V | * Max. PV voltage: 100V | ||
* Max. PV current: 15A | * Max. PV current: 15A |
Revision as of 21:05, 2 December 2016
The BlueSolar series of charge controllers are some of the latest and most efficient MPPT controllers available. The BlueSolar 100-15 controller is based on a Freescale MC9S08AC32 40MHz MCU, can handle up to 100V 15A PV installation, hence then model name. This allows up to 400W of PV on a 24V battery setup, which is pretty much for such a relatively small controller.
Specs
- Type: MPPT charge controller with load output
- Micocontroller: Freescale MC9S08AC32 40Mhz MCU
- Switches: MOSFET N-channel 100V/180A/5mOhm, 40V/190A/2.5mOhm for load output
- Max. PV voltage: 100V
- Max. PV current: 15A
- Max. load current: 15A
- Battery voltage: 12V or 24V, auto-detect
- Battery fuse: 20A blade fuse
- Protection: Over-voltage, over-temperature (buck converter), low-battery voltage cut-off, battery management
- Terminals: screw terminals, max. 6mm2/10AWG
- Monitoring: Two LEDs, remote VE Direct RS232 communication cable to a computer or meter device
- Auxilary port: JST-PH 4-pin 2mm pitch connector, pinout GND-RX-TX-5V
- Firmware: Upgradable via VE Direct RS232 cable and software
- Size: 113.9 x 100.7 x 46.9 mm
Schematic
The following is a partial reverse-engineer of the power stage of the charge controller, no logic or support circuitry is included.